How to fold the planes from Paper Plane Launcher

The machine in the game folds three classic designs. Here they are step by step, the same folds in the same order, so you can make them with a real sheet of paper. Ordinary printer paper works best. Crease every fold hard with a thumbnail, and keep the two halves matched: a lopsided plane turns.

Measurements for

fold towards you fold away from you front of the sheet back of the sheet

Dart

The classic schoolyard plane: narrow, pointed and quick. In the launcher it has the highest ceiling when it is thrown hard and fairly flat.

  1. 1Fold the sheet in half the long way, crease it hard, then open it flat again. That centre line is the guide for every fold after it.

  2. 2Fold both top corners in so their top edges lie along the centre line. You now have a triangle at the top.

  3. 3Then the other corner, the same way, so both meet on the centre line.

  4. 4Fold the new slanted edges in to the centre line as well. The point gets sharper; the folds should meet the side edges about 253 mm from the top.

  5. 5Then the other edge, the same way.

  6. 6Fold it in half along the centre line, away from you, so the folded flaps stay on the outside.

  7. 7Lay it on its side, nose to the right. Fold the wing down so its top edge lines up with the bottom of the body: the body ends up about 53 mm deep at the back and close to nothing at the nose. Turn it over and fold the other wing to match.

  8. From the side, and from behind

    DoneOpen the wings so they sit level, or tilted up a touch, so it makes a shallow Y from behind. Hold the body underneath, just behind the middle, and throw it hard and straight.

Fold a Dart in the launcher

Glider

Wide wings and a folded-down band across the nose for weight up front. Slow and steady with a gentle throw; throw it hard and the big wings flutter.

  1. 1Fold the sheet in half the long way, crease it hard, then open it flat again. That centre line is the guide for every fold after it.

  2. 2Fold the top edge down 63 mm, towards you, and crease it flat. That doubled band is the nose weight.

  3. 3Fold both top corners in to the centre line, folding through the band as well. The nose becomes a right-angled point.

  4. 4Then the other corner, the same way, so both meet on the centre line.

  5. 5Fold it in half along the centre line, away from you, so the folded flaps stay on the outside.

  6. 6Lay it on its side, nose to the right. Fold the wing down along a line 40 mm above the bottom of the body at the back and 19 mm at the front, where the wing starts. A short point of the body stays ahead of the wings; that is how this design looks. Turn it over and fold the other wing to match.

  7. From the side, and from behind

    DoneOpen the wings level. Hold it under the body near the front and launch it gently, nose very slightly down, as if posting a letter.

Fold a Glider in the launcher

Nakamura Lock

A blunt, sturdy plane whose last small flap locks the nose folds in place. It wants a firm, flat throw, and in the launcher it is the best of the three into a headwind.

  1. 1Fold the sheet in half the long way, crease it hard, then open it flat again. That centre line is the guide for every fold after it.

  2. 2Fold both top corners in so their top edges lie along the centre line, as for a Dart.

  3. 3Then the other corner, the same way, so both meet on the centre line.

  4. 4Fold the whole triangle down along its bottom edge. Its point lands on the centre line, 210 mm from the top of the sheet.

  5. 5Fold the new top corners in to the centre line so they meet about 32 mm above the triangle's point, leaving a flat nose about 54 mm wide. Start each fold 78 mm in from the side.

  6. 6Second corner: fold it in to meet the first on the centre line.

  7. 7Fold the little point up over the two corners, along a line 29 mm above its tip. This small flap is the lock that holds the nose together.

  8. 8Fold it in half along the centre line, away from you, so the lock stays on the outside. You should see the small lock triangle on both sides.

  9. 9Lay it on its side, nose to the right. Fold the wing down along a line 43 mm above the bottom of the body at the back and 11 mm at the front. Turn it over and fold the other wing to match.

  10. From the side, and from behind

    DoneOpen the wings level. Pinch the body under the lock and throw firmly and flat, not upwards.

Fold a Nakamura Lock in the launcher

If it won't fly straight